Justin Delaski Posted August 7, 2020 Report Share Posted August 7, 2020 Any suggestions on where to source grommets for the ends of the rod tubes? Quote Link to comment Share on other sites More sharing options...
Tails Up Posted August 8, 2020 Report Share Posted August 8, 2020 Last time this came up someone suggested replacementboatparts.com. I do not have any experience with them but may someone will chime in. Quote Link to comment Share on other sites More sharing options...
SCFD rtrd. Posted August 9, 2020 Report Share Posted August 9, 2020 Try TH Marine. Quote Link to comment Share on other sites More sharing options...
bernieNC Posted August 10, 2020 Report Share Posted August 10, 2020 Is this what you are looking for? https://thmarinesupplies.com/products/utility-grommet-fishing-rod-grommet Quote Link to comment Share on other sites More sharing options...
DaveC Posted August 10, 2020 Report Share Posted August 10, 2020 Don't forget to check the diameter, my 2000 17' MA had different openings and I couldn't find anything that fit at all... and I am in the biz! Quote Link to comment Share on other sites More sharing options...
Justin Delaski Posted August 13, 2020 Author Report Share Posted August 13, 2020 Thank you everyone! Quote Link to comment Share on other sites More sharing options...
Fsu11 Posted August 13, 2020 Report Share Posted August 13, 2020 my buddy used Office Desk "wire" grommets, the plastic circles you see installed on a desk for the wires to go through, he found some at ace hardware that worked. Quote Link to comment Share on other sites More sharing options...
brudnlaw65 Posted August 13, 2020 Report Share Posted August 13, 2020 Quote Link to comment Share on other sites More sharing options...
bernieNC Posted August 13, 2020 Report Share Posted August 13, 2020 32 minutes ago, brudnlaw65 said: I would question UV tolerance but other than good idea. Quote Link to comment Share on other sites More sharing options...
Justin Delaski Posted October 8, 2020 Author Report Share Posted October 8, 2020 Brilliant hack. We did 3D print some but we will try a combination of the printed and the wire management pieces. Quote Link to comment Share on other sites More sharing options...
Shallowminded6 Posted October 8, 2020 Report Share Posted October 8, 2020 10 hours ago, Justin Delaski said: Brilliant hack. We did 3D print some but we will try a combination of the printed and the wire management pieces. Post how it goes, I need to get some as well. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.