Ms. Magoo Posted December 27, 2015 Report Share Posted December 27, 2015 Getting use to my new 2400 trs and I am having a couple of issues. I have a factory installed 8 ft pole power. It is spraying the rider sitting in the jump seat. Is anyone else having this issue? Is this normal? I am loving the boat. Thanks for the help. Link to comment Share on other sites More sharing options...
FINCHASER Posted December 27, 2015 Report Share Posted December 27, 2015 Id venture to say it was mounted to low. Are you sure that's what is causing it cause transducers are famous for kicking up spray. Take a careful peek over the transom when running to see exactly whats going on Link to comment Share on other sites More sharing options...
Ms. Magoo Posted December 27, 2015 Author Report Share Posted December 27, 2015 I bet you are correct. I will check the transducer today. Link to comment Share on other sites More sharing options...
fin-addict Posted December 27, 2015 Report Share Posted December 27, 2015 I would think the trans is causing it. while running the stern lifts which would raise the pp. Link to comment Share on other sites More sharing options...
tribbsa Posted December 27, 2015 Report Share Posted December 27, 2015 I had same problem with the transducer. Tried adjusting, shields, nothing seem to really work. Finally went to shoot thru. That's what I'll always install from this point forward. Link to comment Share on other sites More sharing options...
northernsnooker Posted December 28, 2015 Report Share Posted December 28, 2015 I had that issue with my 2015 2200 trs. It was the transducer. Garmin sent me a shield for free and problem solved. Link to comment Share on other sites More sharing options...
FishEyez Posted December 29, 2015 Report Share Posted December 29, 2015 I had the same problem with the transducer on my 22 TE. Transom mounted I adjusted it a little to where I was still getting a reading and it calmed it down a little but not completely. Link to comment Share on other sites More sharing options...
Ms. Magoo Posted December 29, 2015 Author Report Share Posted December 29, 2015 Thank you all very much. The transducer is the problem. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.