So I recently replaced my jack place switch that is mounted on the binnacle throttle. Pictured below. I ran the wires like the old ones were along with the trim and tilt wire. When i put it all back together and moved the throttle to make sure it was functioning properly ... it doesn't go into reverse normally.... sometimes it feels normal ... most times it feels like that trim and tilt wire in binding around the base of the throttle lever. (I took the cover off and moved the throttle and could see where the trim and tilt wire was bowing out when I would move the throttle in reverse) Does this make sense ? Has anyone else had this issue and have any recommendations?